Sagging Framing
A bay that dips between frames needs structural repair. That work goes beyond coating and calls for a question to the state office.

Nicholas County · Clear Scope
We offer metal roof coating in Carlisle for shops and storefronts, keeping the job to screws, laps, and coating when the roof allows it.
The fewer surprises in the scope, the simpler the job. We write it down before any work starts.
Nicholas County's state listing names no local building inspector and sends commercial construction to the Kentucky HBC. A Carlisle job that stays at coating, fastener replacement, and lap sealing is the simplest case.
New panels, new rooftop penetrations, or a rebuilt section of framing are where you ask the state office what review applies. A short written scope and a few roof photos answer most first questions.

These six findings change the scope. We flag them on the walk.
A bay that dips between frames needs structural repair. That work goes beyond coating and calls for a question to the state office.
Rust-through means new sheets. A few patch plates stay simple; a whole section of new panels changes the scope.
Adding a vent, a unit, or a conduit run through the roof cuts new holes. Those get flashed and coated with the field.
Conduit strapped across the steel has to be lifted for fastener work, which brings electrical inspection into the job.
Holes worn oversize no longer grip a standard screw. Oversized fasteners keep the job at fastener work instead of new panels.
Side laps with too few stitch screws open in wind. Adding stitch screws stays inside a simple coating scope.
A Carlisle roof kept to a coating scope pays off for the people who own and run the building.
Most Carlisle roofs end up on one of these four paths.
The simplest scope: screws, laps, primer, and a field coat.
Low sections that hold water take silicone after the cause is fixed.
Sloped, well-drained panels take a light acrylic coat.
Shops that lose heat through bare panels can take foam and a topcoat once the scope is settled with the state office.
A leak at a screw line or lap on a Carlisle building? Call and tell us where the water lands.
Call UsWant a number before writing a scope? Get a ballpark range in a few minutes.
Get A Free Ballpark EstimateThe scope gets written before the work starts, and anything beyond coating gets flagged early.
We walk the whole roof and look inside, noting every screw row, lap, and rusted panel with photos.
The work gets listed by roof area, with anything beyond coating flagged for a call to the state office.
Screws get replaced, laps sealed, and rust primed across the field.
The field is coated to the specified thickness and checked on a final walk.
A closing walk measures film thickness on the roof, and photos of the finished work go on file with the written scope.
We coat roofs in Carlisle and nine more towns, all shown below. Outside our area? Call us or send us a message.
7,558Residents · Montgomery County
County seat; roof units and vent boots first.
1,193Residents · Powell County
Powell County; storm checks on roof trim and ribs.
1,708Residents · Montgomery County
Pole barn roofs coated without new panels.
1,593Residents · Bath County
Bath County seat; storefront and steel roofs.
601Residents · Menifee County
Menifee County seat; skylight panels sorted first.
365Residents · Bath County
Bath County; purlins and holed panels fixed first.
747Residents · Bourbon County
Bourbon County; ridge caps and roof closures first.
610Residents · Bourbon County
Bourbon County; service masts at the roof edge.
1,020Residents · Montgomery County
Montgomery County; gutters and eave trim on shops.
Figures: 2020 U.S. Census counts for each city.
The Kentucky HBC issues them, because the state's Nicholas County listing names no local inspector and sends commercial construction to the state.
Jobs that stay at coating, fastener replacement, and lap sealing are the simplest case. Ask the state office about panels, new penetrations, or framing.
Electrical inspection goes to the city or the Nicholas County Judge Executive, depending on where the building stands. The same listing names HVAC, plumbing, and state electrical inspectors.
Lifting conduit, disconnecting a unit, or replacing vent boots brings those trades in, so schedule them ahead of coating.
Firm steel, surface-only rust, and no changes to the roof's structure or penetrations. Then the job is screws, laps, primer, and a field coat.
The walk tells us early if your roof fits that description.
A few holes get patch plates and the job stays a coating. Rust-through across a whole section calls for new panels instead.
Patch plates get primed and coated with the rest of the field.
Yes. A few photos of the roof and of stains inside help us plan the walk and spot scope questions early.
Mark leak spots on a rough floor plan if you can.
Coating alone often stays outside permit review, but ask the Kentucky HBC with your written roof scope before work starts.
Panels, new penetrations, or framing are where review usually applies.
Start with a ballpark range, or call to talk through the scope.
Or call (859) 204-8099
Leave a name and number and we will call you about the roof.
Rather talk now? Call (859) 204-8099